Prefabricated substation installation and operation

Oct 17, 2026 Leave a message

The enclosure doors of prefabricated substations should open outwards and have handles, concealed latches, and locks. The latches and locks should be rust-proof. The transformer room should primarily rely on natural ventilation, and a curve showing the relationship between the internal temperature and transformer output should be provided. The transformer room may be equipped with a room temperature monitoring device and a self-starting ventilation and cooling system as needed to ensure the transformer operates at full load under specified environmental conditions. The transformer should be accessible through the top or side door of the enclosure. The noise level of the prefabricated substation should not exceed the specified transformer noise level. Regardless of whether the enclosure is made of metallic or non-metallic materials, the metal frame of the enclosure should have good grounding, a grounding terminal, and a clearly marked grounding symbol.

 

Prefabricated substations primarily rely on natural air circulation for cooling. Therefore, no unauthorized materials should be piled up around it, especially the transformer room door should not be blocked, and any adhering materials on the louvered ventilation openings should be regularly cleaned to ensure that all electrical equipment does not exceed the maximum permissible temperature. After a low-voltage circuit breaker trips, the cause of the trip should be investigated before attempting to restore power. If restoration is unsuccessful, the cause of the fault must be thoroughly investigated and eliminated before power can be restored to prevent the accident from escalating. Zinc oxide surge arresters should be installed in the high-voltage distribution room of the box-type transformer, and the installation method must facilitate testing, disassembly and replacement.

info-800-800